srakaonline.blogg.se

1. #TERMINAL MAC SHUTDOWN COMMAND IN THE FUTURE PASSWORD#
2. #TERMINAL MAC SHUTDOWN COMMAND IN THE FUTURE PC#

Assuming the switch had no configuration file stored in nonvolatile random-access memory (NVRAM), A console connection using Tera Term or other terminal emulation program will place you at the user EXEC mode prompt on the switch with a prompt of Switch>. Use the enable command to enter privileged EXEC mode.Ī. The privileged EXEC mode command set includes those commands contained in user EXEC mode, as well as the configure command through which access to the remaining command modes is gained. You will set passwords later in this lab.

#TERMINAL MAC SHUTDOWN COMMAND IN THE FUTURE PASSWORD#

Access to privileged EXEC mode should be restricted by password protection to prevent unauthorized use because it provides direct access to global configuration mode and commands used to configure operating parameters. You can access all the switch IOS commands in privileged EXEC mode. In this step, you will examine the default switch settings, such as current switch configuration, IOS information, interface properties, VLAN information, and flash memory. Step 2: Verify the default switch configuration. A Cisco 2960 switch first placed into service has no networking configured. No IP addressing parameters are configured yet. Why must you use a console connection to initially configure the switch? Why is it not possible to connect to the switch via Telnet or SSH? Connect to the switch from PC-A using Tera Term or other terminal emulation program. This has the same effect as not connecting PC-A to S1.ī. Note: If you are using Netlab, shut down F0/6 on S1. Do not connect the PC-A Ethernet cable at this time. Connect the console cable as shown in the topology. Step 1: Cable the network as shown in the topology.Ī. In Part 1, you will set up the network topology and verify default switch settings. 1 Ethernet cable as shown in the topology Part 1: Cable the Network and Verify the Default Switch Configuration.1 Console cable to configure the Cisco IOS device via the console port.

#TERMINAL MAC SHUTDOWN COMMAND IN THE FUTURE PC#

Depending on the model and Cisco IOS version, the commands available and output produced might vary from what is shown in the labs. Other switches and Cisco IOS versions can be used. Note: The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.2(2) (lanbasek9 image). The topology consists of one switch and one host using only Ethernet and console ports. You will also demonstrate the use of a management IP address for remote switch management. These basic switch settings include device name, interface description, local passwords, message of the day (MOTD) banner, IP addressing, and static MAC address. You will examine default switch configurations before configuring basic switch settings. In this lab, you will build a simple topology using Ethernet LAN cabling and access a Cisco switch using the console and remote access methods. If the VLAN 1 SVI is assigned an IP address, by default all ports in VLAN 1 have access to the SVI IP address.

The SVI, or management address, can be used for remote access to the switch to display or configure settings. Background / ScenarioĬisco switches can be configured with a special IP address known as the switch virtual interface (SVI). List the show mac address-table command options.Determine the MAC addresses that the switch has learned.Test remote management capabilities with Telnet.Test end-to-end connectivity with ping.Part 3: Verify and Test Network Connectivity 1.1.7 Lab – Basic Switch Configuration Addressing Table Device Interface IP Address / Prefix S1 VLAN 99 192.168.1.2 /24 2001:db8:acad::2 /64 fe80::2 PC-A NIC 192.168.1.10 /24 2001:db8:acad:3 /64 fe80::3 Objectives Part 1: Cable the Network and Verify the Default Switch Configuration Part 2: Configure Basic Network Device Settings